This project was an old factory in Cheltenham Victoria. The owners of the factory had the walls painted, a new office installed and a new ceiling.
We quoted to remove vinyl tiles that were on the floor from a previous textile business that operated in the factory for many years. We removed about 3.5 tonnes of vinyl tiles from the floor and then removed the tile adhesive with concrete grinders.
Due to the age of the floor we had a lot of holes to fill in the floor to create a smooth surface to coat with epoxy resin.
Below are the photos of the finished floor once we applied the epoxy resin to the prepared factory floor.
To be able to apply the epoxy resin to the floor and create a flat surface we needed to apply a primer coat so we could seal the concrete. Otherwise air bubbles can come through the concrete and create small bumps on the finished epoxy coating.
First we needed to remove the vinyl tiles from the floor. We used a floor scrapper to remove the tiles. We removed about 3.5 tonnes of vinyl tiles from the floor. Then we needed to grind off the tile adhesive.
This project took about one week to complete. The epoxy coating was complety cured after 3 days.